Mechanical Engineer

Key Responsibilities

1. Design & Development

• Design mechanical systems for HVAC (Heating, Ventilation, and Air Conditioning), plumbing, firefighting, and drainage in residential, commercial, and industrial buildings.
• Perform heat load calculations, duct sizing, pipe sizing, and pump head calculations using relevant design software (e.g., HAP, DuctSizer, Elite, etc.).
• Develop detailed mechanical layouts, schematics, and single-line diagrams.
• Ensure designs comply with local authority regulations (e.g., DM, DCD, DEWA) and international standards (ASHRAE, SMACNA, NFPA, CIBSE).

2. Documentation & Technical Reports

• Prepare technical specifications, design reports, and Bills of Quantities (BOQ).
• Review and approve shop drawings, material submittals, and as-built drawings submitted by contractors.
• Prepare tender documents and assist in technical evaluations during the bidding stage.

3. Project Coordination

• Coordinate with architectural, structural, electrical, and civil teams to ensure fully integrated designs.
• Attend design coordination and client meetings to discuss project progress and design issues.
• Liaise with contractors, suppliers, and clients throughout all project stages.

4. Site Supervision & Inspection

• Conduct site inspections to ensure that installation and workmanship comply with approved drawings and specifications.
• Verify testing and commissioning of mechanical systems.
• Monitor compliance with health and safety requirements on site.

5. Compliance & Quality Assurance

• Ensure all mechanical systems meet energy efficiency, environmental, and safety standards.
• Incorporate sustainable design principles, such as energy recovery systems, water-saving fixtures, and green building practices.
• Support LEED, Estidama, or sustainability certifications when applicable.

6. Value Engineering & Optimization

• Propose cost-effective design alternatives and system improvements without compromising functionality or performance.
• Participate in value engineering sessions and optimize equipment selection for performance and efficiency.

7. Leadership & Technical Support

• Provide technical guidance and mentoring to junior engineers and CAD technicians.
• Review and check design deliverables prepared by the mechanical team.
• Stay updated with technological advancements and industry best practices.

Requirements:

1. Must be a graduate of Mechanical Engineering

2. Must have a minimum experience of 5 years, not less than 2 years in Dubai

Job Type: Full-time