Finisher

2nd Shift - Monday - Friday; 3:00pm - 11:30pm

• SAFETY practices MUST be exercised by each operator at all times.
• Use safety devices and equipment provided.
• Refer to shop manual procedures and types of edge finishing.
• Finishers will set rolls on finish table, straighten spirals so they are uniform and connect panels with connecting crimp.
• Once table load is set up, confirm “spirals per foot” from the entry on the shop order.
• Apply tension and trim spirals.
• Square the belt.
• Weld edges of belt in accordance with type of edge required.
• Inspect belt.
• Take belt to shipping department once approved by department supervisor